Hi,

I'm currently drawing up plans for a cloud template and I'm trying to work out the dimensions of the headstock. If you have built a cloud, could you measure the width at it's widest points and also length from back of the nut to 1) point an 2) curly bit as they're both different lengths.

I know the official Prince cloud has a longer pointy bit than the schecter's but I'd like to try to get it as close as possible.

Thanks,
Luke.

Using the templates from the Bristol directory website which is now down, I enlarged the headstock so I had a nut width of 1 5/8" ~= 41mm, I get to the pointy bit, 168mm and to the curly bit, 151.5mm and width of 60mm.

But the image from that website actually says the nut width is 45mm (when it's more likely to be 1 11/16" ~= 42mm) and headstock length of 190.5mm.

So, I'm just interested in other's measurements.

Thanks,

Luke.